"Single Line", Image created in p5js using javascript.
Bike Computer
Based on a Raspberry Pi Pico W, GPS module, modified SD card and eInk Display
eInk display for visibility in direct sunlight
Designed and 3D printed an enclosure and mount to attach the device to my road bike
Programmed in C, C++, MicroPython with a web interface to upload activities to Strava
Parsed GPS data stream for desired data and created routine to periodically upload data to the SD card avoiding GPS read cycles, saving power and preventing write errors
Retrofit of old Kerosene Lamp
Used scraps from partial LED strips that were to be thrown away
Potentiometers for Red, Green, Blue control and power switch
3D printed enclosure.
Moisture Sensing Smart Plant Pot
Created custom Bitmap images to mirror the image of the plant
Used a Raspberry Pi Pico W with Arduino Core (written in C++).
Screen can be turned on and off from local address.
Moisture levels can be monitored via online dashboard.
OLED display to indicate the plant’s “happiness level.
Automated Indoor Grow System
Automated indoor grow system for growing microgreens
Arduino based control system
Automated watering and lighting
Test various moisture profiles
Personal eBike
Built and designed many iterations. Diagnosed electrical equipment failures.
Calculated power and torque requirements for the hills nearby.
Designed and soldered battery pack for power requirements.
Rewired the motor with lower gauge wire for higher current.
This page is a work in progress (and also a project of mine)
Written in React.
I will be adding new things here from time to time.
